Lance atomizers for continuous casting

In continuous casting, and in slab casting in particular, lance atomizers replace conventional compact atomizers, currently called block atomizers, where the atomizer body is equipped with an extension and the spray tip is located at the exit end of the extension. The reasons of this replacement are due either to the geometrical need to insert the spraying pipe between rolls, whose clearance is often very small and prevents the use of block atomizers, or to the convenience to position the feeding pipes far from the intensely heated area near the slabs.

Starting from today, you can find on our website two different lance atomizers:

You can find these atomizers both in the “Special Atomizers” section (http://www.pnr.eu/prodotti/special-atomizers/) and in the “Continuous casting” section, below Metals Industry (http://www.pnr.eu/metals-industry/cooling/continuous-casting/).

Lance atomizers can be classified according to different parameters:
Atomizer’s body: the body where atomization is generated is matched by a plug-in connection to fluid feeding ducts, may have different shapes according to the model and may be casted (MB) or machined (MT).
Geometry of the pipe: straight pipe, or bent type.
Connections of the pipe to the body: the extension pipe is welded onto the block body, or the extension pipe is screwed to the block body with a locknut.

Moreover, in our “Brochures” section (http://www.pnr.eu/brochures/) you can find the dedicated brochure, with more information.

If you need any further information, please feel free to contact us by mail ([email protected]) or by phone (+39.0383.344646)!

Lance atomizers for continuous casting

www.pnr.eu
[email protected]
+39 0383 344611

In continuous casting, and in slab casting in particular, lance atomizers replace conventional compact atomizers, currently called block atomizers, where the atomizer body is equipped with an extension and the spray tip is located at the exit end of the extension. The reasons of this replacement are due either to the geometrical need to insert the spraying pipe between rolls, whose clearance is often very small and prevents the use of block atomizers, or to the convenience to position the feeding pipes far from the intensely heated area near the slabs.

Starting from today, you can find on our website two different lance atomizers:

You can find these atomizers both in the “Special Atomizers” section (http://www.pnr.eu/prodotti/special-atomizers/) and in the “Continuous casting” section, below Metals Industry (http://www.pnr.eu/metals-industry/cooling/continuous-casting/).

Lance atomizers can be classified according to different parameters:
Atomizer’s body: the body where atomization is generated is matched by a plug-in connection to fluid feeding ducts, may have different shapes according to the model and may be casted (MB) or machined (MT).
Geometry of the pipe: straight pipe, or bent type.
Connections of the pipe to the body: the extension pipe is welded onto the block body, or the extension pipe is screwed to the block body with a locknut.

Moreover, in our “Brochures” section (http://www.pnr.eu/brochures/) you can find the dedicated brochure, with more information.

If you need any further information, please feel free to contact us by mail ([email protected]) or by phone (+39.0383.344646)!

PNR Italia 27058 Voghera (PV) Italy – Via Gandini 2
Phone: +39 0383 344611 Fax: +39 0383 212489 E-mail: [email protected]