Project Description

BF/BH
Full Cone Nozzle

www.pnr.eu
[email protected]
+39 0383 344611

BF BH FULL CONE NOZZLE – X-VANE, SQUARE SPRAY PATTERN, TWO-PIECE DESIGN

BF BH full cone nozzle has a simple two-piece design producing a square section spray pattern. They are the convenient choice where the coverage of a surface is required to be as even as possible. Their X-vane ensures uniform spray distribution and resistance to clogging, also when working with large capacities. The sides of the square spray section are not aligned with the grooves of the nozzle orifice and the offset angle is between 10° and 15° depending on working pressure and distance from the impact surface. Therefore, utmost attention must be paid during the nozzles overlay setting. They must be carefully aligned and adjusted according to the operating situation.

Materials
AISI 303 s.s.
AISI 316L s.s.
Brass

Thread specification
Male BSPT, NPT
Female BSP, NPT
From 1/8″ to 6″

PNR Italia 27058 Voghera (PV) Italy – Via Gandini 2
Phone: +39 0383 344611 Fax: +39 0383 212489 E-mail: [email protected]

BF/BH

FULL CONE NOZZLE

Materials

AISI 303 s.s.
AISI 316L s.s.
Brass

More materials on request

Thread specification

Male BSPT, NPT
Female BSP, NPT

From 1/8″ to 6″

BF/BH

FULL CONE NOZZLE

Materials

AISI 303 s.s.
AISI 316L s.s.
Brass
More materials on request

Thread specification

Male BSPT, NPT
Female BSP, NPT

From 1/8″ to 6″

BF / BH

FULL CONE NOZZLE

Materials

AISI 303 s.s.
AISI 316L s.s.
Brass
More materials on request

Thread specification

Male BSPT, NPT
Female BSP, NPT

From 1/8″ to 6″

BF BH FULL CONE NOZZLE – X-VANE, SQUARE SPRAY PATTERN, TWO-PIECE DESIGN

BF BH full cone nozzle has a simple two-piece design producing a square section spray pattern. They are the convenient choice where the coverage of a surface is required to be as even as possible. Their X-vane ensures uniform spray distribution and resistance to clogging, also when working with large capacities. The sides of the square spray section are not aligned with the grooves of the nozzle orifice and the offset angle is between 10° and 15° depending on working pressure and distance from the impact surface. Therefore, utmost attention must be paid during the nozzles overlay setting. They must be carefully aligned and adjusted according to the operating situation.

CLJet deflection angledegDULiquid outlet diammRFFemale threadinch
DConventional orifice diammFFFlange outer diammRGMale threadinch
D1Smallest free inside diammGFlange center-hole diammSQSquare bar sizemm
DELiquid inlet diammH,H1HeightmmWWeightgr, kg
DFFlange sizeinchL,L1LengthmmWSWrench sizemm
DIAOutside diametermmNRNumber of orifices
DNFlange nominal sizemmQCQuickfit connection

+39 0383 344611