Project Description

UAC

FIXED HEAD

Materials

AISI 316L s.s.
Hastelloy C276
Titanium Gr2

Thread specification

Female BSPP – NPT
From 1/8″ to 1-1/4″

Clip-on
Welded

UAC

FIXED HEAD

Materials

AISI 316L s.s.
Hastelloy C276
Titanium Gr2

Thread specification

Female BSPP – NPT
From 1/8″ to 1-1/4″

Clip-on
Welded

UAC

FIXED HEAD

Materials

AISI 316L s.s.
Hastelloy C276
Titanium Gr2

Thread specification

Female BSPP – NPT
From 1/8″ to 1-1/4″

Clip-on
Welded

UAC

UAC fixed spray heads are a simple, fast and efficient device for cleaning the inside of small size tanks where a simple rinsing action is required. Because of the relatively high washing fluid flow rate, they are usually operated at low pressures and can achieve a limited impact action on the tank wall.
Their simple design allows for the head to be easily cleaned after being operated, which makes it possible to leave the heads permanently in place ready for use. The values for wetting radiuses shown at the right of the table have been obtained operating the heads with a water pressure value of 1 bar.
On request, heads with electropolishing Ra < 0,8 µm are available, in order to have roughness for alimentary applications.

DeExternal diametermmL, L1
WidthmmRFFemale threadinch
DiInner diametermmLPMax working pressurebarRGMale threadinch
DiaOrifice diametermmLTMax working temperature°CWWeightkg
DNNominal diameterQCapacityl/minWRWetting radiusm
H, H1
Heightmm

In 2016, Standard DIN 11866 gathered some of the most important standards regarding inox pipes. Some of our products can already couple to pipes respondent to these standards. Pipes with dimensions in compliance with obsolete standards are very common, therefore they are still produced without problems by PNR Italia. We are also available to guarantee the connection with every pipe that has a thickness within the standard values. In the following table you can find the dimension we can provide.





+39 0383 344611

Letters labeled with a * in the section “Spray Patter” specify that those models can’t be realized with “Connection Size” = 1/8” (letter A).

Letters labeled with a * in the section “Spray Patter” specify that those models can’t be realized with “Connection Size” = 1/8” (letter A).

Threaded

Clip-on